Actian X 11.2 | Check for Data Access Server Process on Linux

System Administrator Guide > System Administrator Guide > Troubleshooting Actian X > Actian X Processes on Linux > Check for Data Access Server Process on Linux

Was this helpful?

Check for Data Access Server Process on Linux

The command to start the Data Access Server process (iigcd) from the installation owner login is ingstart -iigcd. If the Data Access Server did not start:

1. Verify that the recovery process (dmfrcp) is running. For more information, see Check for Recovery Process Errors on Linux.

2. Verify that the recovery process not in a recovery state. (See Recovery Process Monitoring.) This is likely if there was a sudden shutdown because of a power failure or other systems failure.

3. Try to start up a Data Access server. Issue the following command at the operating system prompt:

ingstart -iigcd

4. If you corrected a Data Access server problem, verify that Actian X starts normally:

a. Shut down the partially started installation with the ingstop command.

b. Restart the installation with the ingstart command.

Last modified date: 04/03/2024