3. Starting Ingres : Start Ingres on OpenVMS
 
Share this page                  
Start Ingres on OpenVMS
You are ready to start the Ingres installation after you have installed the software and set up the required configuration parameters for each component.
To start your installation
1. Log on to your system through the system administrator account for your installation.
2. Enter the following command:
$ @II_SYSTEM:[ingres]ingsysdef.com
The symbols needed to start the installation are defined.
3. Enter the following command to start your installation:
$ ingstart
Ingstart checks that you have sufficient operating system resources to run the Ingres components; if not, it issues an error message and exits. If resources are sufficient, all servers are started.
To stop your installation
Enter the following command:
$ ingstop
Components of your installation that are running are shut down.