It is possible to specify B-tree index page fill factors at modify time. This is the percentage of the index page that is used during the modify procedure. The remaining portion of the page is available for use later when new rows are added to the table. The purpose of the fill factor is to leave extra room on the index pages to do inserts without causing index page splits. This is useful if you modify a table to B-tree and plan to add rows to it later.

In VDBA, you control these values using the Nonleaffill options in the Structure of Index dialog.

The Nonleaffill option specifies the percentage of each index page that is to be filled at the time the table is modified to B-tree. That is, it is similar to Leaffill, but for index pages instead of leaf pages. The Nonleaffill default is 80. This means that 80% of the index page is used at modify time and 20% remains empty for future use.

For example, assume that the key-tid pair requires 500 bytes of storage. This means that four key-tid pairs fit on a single B-tree index page. However, if the index page fill factor is specified at 75%, only three key-tid pairs are allocated on each 2 KB B-tree index page at modify time. If subsequent updates to the table cause another leaf page to be allocated, the empty space on the index page is used to hold a key-tid pair for that new leaf page. If there are enough new rows to cause two new leaf pages to be added to that index page, the index page must split. For more information, see Tids (see page Tids).

Setting a fill factor of lower than 60 on leaf pages can help reduce locking contention when B-tree leaf pages are splitting, because index splitting is reduced. Setting Leaffill low for small but quickly growing B-trees is advisable.

When you specify a high Leaffill, index splitting is almost guaranteed to occur because leaf pages immediately fill up when data is added. Thus, you want to avoid a high fill factor unless the B-tree table is relatively static. Even in this case, use an ISAM table.