5. Configuring Replication Using Replicator Manager : How You Configure Replicator Using Replicator Manager
 
Share this page                  
How You Configure Replicator Using Replicator Manager
To configure Ingres Replicator, you should perform each of the following configuration procedures in the order shown. Perform these procedures on test tables first, before you register production tables for replication.
1. Create Replicator Catalogs on full peer and protected read-only targets.
For details, see repcat Command—Create Replicator Catalogs.
2. Start Replicator Manager from a database that has a full peer CDDS
For details, see Run the Replicator Manager the First Time.
3. Define the local database.
For details, see Run the Replicator Manager the First Time.
4. Define other replicated databases.
For details, see Add a Database to the Database Summary List.
5. Create your CDDS definitions.
For details, see Add a CDDS.
6. Specify CDDS databases.
For details, see CDDS Database and Servers Window.
7. Assign server numbers.
For details, see CDDS Database and Servers Window.
8. Enter your propagation paths.
For details, see Propagation Path Definition Window.
9. Register tables.
For details, see Register Tables.
10. Create support objects for your registered tables.
For details, see Create Support Objects.
11. Create replicated transaction keys, if necessary.
For details, see CreateKeys Options.
12. Move your configuration to other full peer and protected read-only targets.
For details, see Move Configuration Data Window.
13. Activate change recording for any or all CDDSs and databases.
For details, see Activate Change Recording Window.
14. (Optional) Set up an e-mail list on every installation for message notification.
For details, see Create a Mail Notification List.
15. Configure the servers to the settings best suited to your replication system.
For more information, see the chapter "Using Replicator Server."