SunOS (or Sun-4) Dependent LUs
The following example is for SunOS (or Sun-4) dependent LUs. This file is usually in the opt/SUNWconn/snap2p/p2_etc/config directory.
:DEFINE_PU:
pu_name = S1MVS, network_name = RTIBM
contents_id = 01234567
:DEFINE_NODE:
pu_name = S1MVS, node_id = NODE0
:DEFINE_LOCAL_LU:
fql_lu_name = RTIBM.S1115001 # An LU name in VTAM/NCP gen
lu_local_address = 1
lu_name = S1115001 # An LU name in VTAM/NCP gen
lu_session_limit = 1
:DEFINE_PARTNER_LU:
fql_plu_name = RTIBM.A04IS1G2 # VTAM Applid for
# Ingres
# Enterprise Access to DB2
parallel_session = 0 # Must set to this value
cnos_supported = 0 # Must set to this value
remote_is_sscp = 1 # Must set to this value
initiate_type = INITIATE_ONLY
security_acceptance = NONE
:DEFINE_MODE:
mode_name = INGLU62
unique_session_name = s1 # This is the name
# specified
# as the Node Address in
# NETU entries
snd_pac_window = 0 # Recommended
rcv_pac_window = 0 # Recommended
snd_max_ru_size = 4096 # Recommended
rcv_max_ru_size = 4096 # Recommended
sync_level = 0
sess_reinit = INIT_PLU_OR_SLU
auto_activate_limit = 0
session_limit = 1 # Must set to this value
min_conwinner_limit = 1
min_conloser_limit = 0
The following example is for an SDLC connection through the serial port:
:DEFINE_DLC:
dlc_name = XLINK000
device_driver_name = /dev/ifd0
dlc_type = 0
npr_timeout = 240
pause_timeout = 2
idle_timeout = 400 # for maxdata = 1033 & line
# speed = 9600
frm_size = 1033 # [frm_size - 8]
retries = 32
window_size = 7
rxaddr = 0x1
txaddr = 0x1
full_duplex = yes
nrzi = no
multipoint = yes
addr.search = no
switched_line = no
send_reject = no
rcv_reject = no
block_number = 056 # MUST be first of xid
# parameters
id_number = E2E43
abm_support = no
max_btu_rcv = 265
sim_rlm = no
role = secondary
tx_rx_capability = simultaneous
max_btu_rcv = 265
max_rcv_iframe_size = 7
include_control_point = yes # xid control vector
include_link_station_name = yes # xid control vector
product_set_id = 161101130011f9f4f0f4c3f1f0f1f0f0f0f2f4f1f6f4
:DEFINE_ALS:
dlc_name = XLINK000
pu_name = S1MVS
als_name = XXALS000
remote_addr = 0x10