Run the Setup Programs
The setup programs configure the installed components.
You must run the setup programs if the installation process did not perform this step if you used the Install method in Interactive mode—or if you want to change the default values.
After installing Ingres components, you can run the setup programs at any time from the
Currently Installed Components Screen.
The order in which you run the setup programs is important. For a networked DBMS Server instance, run the setup program for the DBMS Server before running Ingres Net Setup. Ingres Net can then use several of the values you specified for the DBMS Server. Run Ingres Star setup last.
To run a setup program
1. Enter the appropriate command, as follows:
$II_SYSTEM/ingres/utility/program_name
where program_name is the name of the setup program, as follows:
iisudbms
DBMS Server setup
iisuc2
C2 Security auditing
iisunet
Ingres Net setup
iisudas
Data Access Server setup
iisubr
Ingres Bridge setup
iisuabf
Applications-By-Forms setup
iisurep
Ingres Replicator setup
iisuodbc
ODBC Driver setup
iisustar
Ingres Star setup
iisurms
RMS Gateway setup
iisukerberos
Kerberos setup
iisusupp32
32-bit support for 64-bit Ingres setup. Valid on reverse hybrid platforms only.
iisuitz
IANA time zone setup
iitzselect
IANA time zone selection
The Setup program for each component displays a description of its purpose and any other important information you should know before setting up the software.
2. Respond to the program prompts.
To accept a default value (which sometimes appears in brackets after the prompt), press Return; otherwise, enter an appropriate value and press Return.
If you do not upgrade all databases during setup, you can upgrade specific databases later, using the upgradedb command (which also runs the utility that upgrades the tools catalogs). For more information, see the Upgrade Guide.
When the Setup programs complete, you are returned to the operating system prompt. Your Ingres installation is now configured.
Last modified date: 01/30/2023