Was this helpful?
[NO]TRACE POINT
SET TRACE POINT activates specified trace points for the current session.
Note:  Trace points are not officially supported, as Actian reserves the right to change their effect and output without notification.
A trace point starts with a Facility Identifier followed by a number of digits. For example:
DM420
DM421
QS501
QE90
SC925
Some trace points have additional parameters. Some trace points are equivalents of SET statements. For example: SET TRACE POINT QE5 is equivalent to SET NORULES.
SET TRACE POINT OP212 is the same as setting TABLE_AUTO_STRUCTURE to ON in CBF.
Caution!  Some trace points may cause irreversible damage to Ingres. Use trace points at your own risk.
Last modified date: 11/28/2023