Installation Guide > Installation Guide > Installing Ingres > Installing Ingres for Linux > Install Ingres Using RPM Commands
Was this helpful?
Install Ingres Using RPM Commands
As an alternative to using the express install script, you can install Ingres by invoking RPM directly.
To install a single package
Invoke RPM with the appropriate installation flags, including the path to the package you want to install, as follows:
rpm ‑ivh path_to_directory/Ingres_package.rpm
To install more than one package at a time
Pass multiple file names, specifying the path to each package, as follows:
rpm ‑ivh path_to_directory/Ingres_package.rpm path_to_directory/Ingres_package2.rpm path_to_directory/Ingres_package3.rpm
To install all packages in the same directory
Specify the following:
rpm ‑ivh path_to_directory/*.rpm
To install a package into a non-default location (that is, with an II_SYSTEM value other than the default)
Use the ‑prefix flag when invoking RPM. The following command installs the specified package with II_SYSTEM=/home/ingres/IngresII:
rpm ‑ivh ‑‑prefix=/home/ingres/IngresII path_to_directory/Ingres_package.rpm
Notes:
• All packages installed in a single instance must have the same value of II_SYSTEM. If you use the prefix flag to install the base package, you must install all subsequent packages with the same –prefix value.
• After you have installed Ingres using the RPM command, you must run the service script, which configures the instance. See Configure and Start the Instance.
Last modified date: 08/29/2024