Data Access Server Errors on VMS
The Data Access Server (II_GCD_nnn, where the nnn is a number related to the server’s process ID) does not start if any of the following conditions occur:
• The II_CONFIG:errlog.log file has a notation regarding the failure of the Data Access Server process.
• The command show system does not list a II_GCD_nnn process.
• The utility iinamu does not display a process name when you enter the command show dasrv at the IINAMU> prompt.
Check for Data Access Server Errors on VMS
Use the following procedure if the Data Access Server process did not start:
1. Verify that you have installed the Ingres Net component.
2. Verify that you have installed the correct protocol drivers and they are functioning properly.
3. Verify the Data Access Server has been properly configured through the Configuration-By-Forms (cbf) utility.
4. If you are still having problems, set the following trace to capture additional diagnostic data before calling technical support:
define II_GCD_TRACE 4
define II_GCD_LOG filename
ingstart -iigcd
Last modified date: 08/29/2024