iisuhdfs Command--Configure Slave Nodes
The iisuhdfs command configures slave nodes in a VectorH cluster.
This command has the following format:
iisuhdfs [option]
option
Specifies one of the following options:
datanodes
Sets up the slave nodes after installation.
genconfig
Updates vectorwise.conf to reflect the current cluster configuration
sync
Syncs all files for slave nodes across all nodes.
sync_config
Syncs configuration files across all nodes.
krbr5
Configures Kerberos settings on all nodes.
yarn
Configures VectorH for YARN integration.
iisuhdfs Example
VectorH is installed on the master node but the slave node setup was skipped. The following command, issued on the master node, sets up the nodes listed in the slaves file:
iisuhdfs datanodes