Check for Data Access Server Process on Linux
The command to start the Data Access Server process (iigcd) from the installation owner login is ingstart -iigcd. If the Data Access Server did not start:
2. Verify that the
recovery process not in a recovery state. (See
Recovery Process Monitoring.) This is likely if there was a sudden shutdown because of a power failure or other systems failure.
3. Try to start up a Data Access server. Issue the following command at the operating system prompt:
ingstart -iigcd
4. If you corrected a Data Access server problem, verify that Actian X starts normally:
a. Shut down the partially started installation with the ingstop command.
b. Restart the installation with the ingstart command.
Last modified date: 08/14/2024